Parts Descriptions; Equipment; Removing The Side Panel; Installing The Motherboard - EVGA HADRON HYDRO Manual De Instrucciones

Parts Descriptions

Equipment

The following accessories are included with the Hadron Chassis:
▪ EVGA Hadron Chassis
The star of the show!
▪ 8pcs M3 x 5mm
These screws are used for the
motherboard, and 2.5" hard drives.
▪ 4pcs M2 x 2.5mm
These screws are used for the
optical disc drive and are
optional.
▪ Power Cable
Connects to an AC power source.
▪ SATA Cable x 2
Use these to connect your hard
.
drive
▪ Optical Disc Drive Tray
A tray for your slim slot load
optical drive.
▪ Manual
All the important information. You
should know, you are reading it
right now!
English
6

Removing the Side Panel

▪ Losen the screws with a phillips screwdriver.
▪ Slide the side panel off in a straight motion.

Installing the Motherboard

▪ Lay the motherboard at a 45 degree angle
inside the chassis and ensure the screw holes
lineup with the standoffs.
▪ Tighten the screws.

Installing the Hard Drive

▪ Pull out the removable hard drive tray by
squeezing together the outer clips.
▪ For 2.5in hard drive: Attach 4 screws to the
bottom of the hard drive tray.
▪ For 3.5in hard drive – Stretch each side of the
hard drive tray and insert the drive.
▪ Slide in the hard drive tray.
English
7