Installing The Pci-E Graphics Card; Connecting Front Panel Led / Usb / Audio Headers; Optical Drive Installation (Optional); Fan Installation / Replacing - EVGA HADRON HYDRO Manual De Instrucciones

Installing the PCI-E Graphics Card

▪ Unscrew the retention clip on the backside of
the chassis, and flip the clip down.
▪ Unscrew the screw.
▪ Insert the graphics card.
▪ Place screw back in, flip up retention clip and
screw in.
▪ Connect power adapters to graphics card.

Connecting Front Panel LED / USB / Audio Headers

▪ Connect the Power LED and Power Switch
cables. Make sure that the Power LED is in
the correct +/- orientation. Please consult your
motherboard documentation on the proper
location for connection.
▪ The USB 3.0 Internal Cable allows for full
support of USB 3.0 devices, please consult
your motherboard documentation to properly
connect this.
▪ The HD audio connector supports HD Audio,
please consult your motherboard
documentation on the proper location of
connection.
English
8
▪ The bundled fans connect to standard 3pin fan
headers on your motherboard.

Optical drive installation (optional)

▪ If you wish to install a slim slot load optical
drive, you can by first removing the opposite
cover.
▪ Insert the optical drive into the optical drive tray
and attach four screws.
▪ Slide in the optical disc tray.
▪ EVGA recommends using the Panasonic
UJ8C5ADPK1-C Slot Load Optical drive.

Fan installation / replacing

▪ If you need to service / replace the included
fans, you can do so by first removing the top
cover.
▪ Remove both screws located on the backside
of the chassis.
▪ Slide out the top cover in a horizontal fashion.
English
9