Congratulations on purchasing our Smokechaser Pro Fire Pump!
• Pump is rust proof and provides a positive shutoff at any position with no drip off or waste of water.
• Combination nozzle allows for operator to change from a straight stream to a cone spray quickly and
easily without any special tools.
• Pump is unaffected by non-use or long periods of storage.
• Shoulder straps are equipped with clips to hold pump, freeing up hands.
• Pump is approved by US Forestry Service.
SAFETY PRECAUTIONS
• Read owner's manual completely before operating this Smokechaser Pro Fire Pump.
• Read and follow all instructions and cautions on label of products used in this Smokechaser Pro Fire Pump.
• Indian Collapsible Bag Fire Pumps are designed to be used for the application of water and water/foam
fire retardants only.
• Do not store or use chemicals other than fire suppressant foam in this bag.
• Never use flammable liquids, caustics, acids, or hot water in this bag.
• Do not leave Smokechaser Pro Fire Pump in the sun when not in use.
• Always inspect hose and all hose connections before each use.
• Do not lift or carry Smokechaser Pro Fire Pump by the hose or pump. Carry by the handle only.
• Clean and rinse Smokechaser Pro Fire Pump thoroughly after each use.
• Never attempt to alter Smokechaser Pro Fire Pump from original condition.
• Keep the Smokechaser Pro Fire Pump out of the reach of children.
Connecting / Disconnecting hose to bag.
When connecting or disconnecting the hose assembly to the
bag, pull down on the outside of the bag quick disconnect
fitting sleeve. This opens up the disconnect fitting so the hose
connector will fit in.
(See Figure 1.)
Push hose connector into the quick disconnect fitting.
(See Figure 2.)
Hose connector is connected correctly when outside sleeve on the
quick disconnect fitting is up as shown. (See Figure 3.)
SAFETY AND ASSEMBLY INSTRUCTIONS
Figure 1.
Figure 2.
Figure 3.
Page 2