sunjoe 24V-X2-BVM190-CT Manual Del Operador página 5

Information about the charger and the
charging process
1. Please check the data marked on the rating plate of the
battery charger. Be sure to connect the battery charger
to a power supply with the voltage marked on the rating
plate. Never connect it to a different mains voltage.
2. Protect the battery charger and its cord from damage.
Keep the charger and its cord away from heat, oil and
sharp edges. Have damaged cords repaired without delay
by a qualified technician at an authorized Snow Joe
Sun Joe dealer or call the Snow Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563).
3. Electrical plugs must match the outlet. Never modify
the plug in any way. Do not use any adapter plugs with
grounded appliances. Unmodified plugs and matching
outlets will reduce the risk of electric shock.
4. Keep the battery charger, battery packs and the cordless
tool out of the reach of children.
5. During periods of heavy use, the battery packs will
become warm. Allow the battery pack to cool to room
temperature before connecting it to the charger to
recharge.
6. Do not overcharge batteries. Do not exceed the maximum
charging times. These charging times only apply to
discharged batteries. Frequent insertion of a charged or
partially charged battery pack will result in overcharging
and cell damage. Do not leave batteries in the charger for
days on end.
7. Never use or charge batteries if you suspect that they
have been more than 12 months since the last time they
were charged. There is a high probability that the battery
pack has already suffered dangerous damage
(exhaustive discharge).
8. Charging batteries at a temperature below 41°F (5°C) will
cause chemical damage to the cells and may cause a fire.
9. Do not use batteries that have been exposed to heat
during the charging process, as the battery cells may have
suffered dangerous damage.
10. Do not use batteries that have suffered curvature or
deformation during the charging process or those that
exhibit other atypical symptoms (gassing, hissing,
cracking, etc.).
11. Never fully discharge the battery packs (maximum
recommended depth of discharge is 80%). A complete
discharge of the battery packs will lead to premature aging
of the battery cells.
Protection from environmental influences
1. Wear suitable work clothes. Wear safety goggles.
2. Protect your cordless tool and the battery charger from
3. Do not use the cordless tool or the battery charger near
4. Use the battery charger and cordless tools only in dry
+
®
+ Sun Joe
® ®
5. Do not keep the battery charger in places where the
6. Protect batteries from overheating. Overloads,
7. Store the charger and your cordless tool only in dry
8. Prevent the lithium-ion battery packs from freezing.
9. When handling batteries, be wary of electrostatic charge.
5
moisture and rain. Moisture and rain can cause dangerous
cell damage.
vapors and flammable liquids.
conditions and at an ambient temperature of 41ºF – 105°F
(5°C – 40.5°C).
temperature is liable to reach over 105°F (40.5°C). In
particular, do not leave the battery charger in a car that is
parked in the sunshine.
overcharging and exposure to direct sunlight will result
in overheating and cell damage. Never charge or work
with batteries that have been overheated – replace them
immediately, if possible.
locations with an ambient temperature of 41ºF – 105°F
(5°C – 40.5°C). Store your lithium-ion battery packs in a
cool, dry place at a temperature of 77°F (25°C). Protect
the battery packs, charger and cordless tool from humidity
and direct sunlight. Only place fully charged batteries in
storage (charged to at least 40%).
Battery packs that were stored below 32°F (0°C) for more
than 60 minutes must be discarded.
Electrostatic discharges can damage the electronic
protection system and the battery cells. Avoid electrostatic
charging and never touch the battery poles.