SHOWJOE iON13SS-CT Manual Del Operador página 10

Pala quitanieve inalámbrica – solo herramienta
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fig. 4
iCHRG40-DPC
green
red
Charging
5. When charging is complete, remove the battery from the
charger by pulling the push lock button and sliding the
battery backward to unlock it from the charger.
6. The iCHRG40 Charger (sold separately) or the
iCHRG40-DPC Dual Port Charger (sold separately)
are also equipped with additional charging indicating
lights which will indicate the charging status (Figs. 3 – 4).
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery.
m
WARNING!
The chargers do not automatically turn
off when the battery is fully charged. Please take care not
to leave the battery plugged into the charger. Switch off or
unplug the charger at the mains when charging is complete.
7. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Assembly
Connecting the Upper and Lower Tubes
1. Before connecting the upper and lower tubes, make sure
the handle knob and bolt are removed from the adjustable
handle, then slide the adjustable handle onto the upper
tube at the middle section (Fig. 5). Reinstall the handle
knob and bolt onto the adjustable handle (Fig. 9).
NOTE: Do not try to install the adjustable handle after the
tubes are assembled.
green
green
Fully charged
10
Fig. 5
Middle
section
Lower tube
2. Slide the upper tube inside the lower tube and align the
screw holes (Fig. 6).
Fig. 6
3. Insert the joint-fixing bolt through the aligned holes in the
upper and lower tubes and secure the other end with the
joint-fixing knob (Figs. 7 & 8).
NOTE: You may have to carefully move the wiring inside
the tube to one side if it blocks the path of the bolt.
(Use the shipping wire to maneuver the electrical wiring;
do not use a sharp tool.)
Fig. 7
Joint-fixing knob
Upper
tube
Adjustable
handle
Upper tube
Lower tube
Joint-fixing bolt

Publicidad

Tabla de contenido
loading

Tabla de contenido