Functional Check - Climbing Technology ROLLNLOCK Guia De Inicio Rapido

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

3) FUNCTIONAL CHECK

3.1
CHECKING MOVING PARTS
• MOVEMENT OF THE MOVING SIDE PLATE - Check that the side plate can rotate completely without sticking. Check that the
side plate returns without sticking and correctly fits over the bushing. If necessary lubricate moving parts with a silicon-based oil
spray, according to the device's instructions for use.
• LOCKING CAM - Check the cam can move freely and without sticking when the sheave position lever is in the unlocked
position. Try releasing it slowly to avoid any spring effect. If necessary lubricate moving parts with a silicon-based oil spray,
according to the device's instructions for use.
• SHEAVE POSITION LEVER - Check the lever moves without sticking. In the locking (ascender/hauling) position, the cam should
not move. If necessary, clean it with compressed air and lubricate moving parts with a silicon-based oil spray, according to the
device's instructions for use.
• ROTATION OF PULLEY - Configure the device as a simple pulley as indicated in the instructions and check the pulley rotates
without sticking. If necessary, clean it with compressed air and lubricate moving parts with a silicon-based oil spray, according
to the device's instructions for use.
• BUSHING - Make sure the side plate bushing is not loose.
3.2
CHECK IN LOCKING MODE
Attach a suitable-diameter rope to an anchor point. Attach the device to the rope in locking (ascender/hauling) mode as
described in the instructions for use. Insert a connector into the connector hole. Pull the device up the rope making sure that the
device moves freely up the rope. Verify the holding power of the locking function by loading the clamp with the weight of the body,
using a webbing previously inserted in the connector. Unlocking the device is only possible when you unload it.
The examiner's verdict on the severity of the anomaly must be based on objective criteria and the specific training received.
The producer accepts no responsibility deriving from inexact information recorded by the user or servicer.
PRO12-2D652CTEN_rev.7 09-19
PERIODIC CHECKING OF
PERSONAL PROTECTIVE EQUIPMENT
ROLLNLOCK

Publicidad

Tabla de contenido
loading

Tabla de contenido