Functional Check - Climbing Technology EASY MOVE Manual Del Usuario

2.3 CHECKING THE CONNECTOR (IF PRESENT)
• Check that the device's EN 362 connector is present.
• Check the condition of the connector by following the relevant inspection procedure and the instructions for use.
2.4 CHECKING THE ROPE (IF PRESENT)
• Verify that the type and dimensions of the rope correspond to what is stated on the labelling and in instructions for use for the
device.
• Check the condition of the rope by following the relevant inspection procedure and the instructions for use.

3) FUNCTIONAL CHECK

3.1 CHECKING THE DEVICE'S MOVING PARTS
• MOVING SIDE PLATE - Make sure the side plate fully turns round, without hindrance or lifting.
If necessary, clean it with compressed air and lubricate with a silicon-based oil spray, according to the device's instructions for
use.
• OPENING PIN - Check the pin can rotate smoothly and without sticking. If necessary, clean it with compressed air and
lubricate with a silicon-based oil spray, according to the device's instructions for use.
• ADJUSTMENT LEVER - The lever must rotate without sticking. Check the spring is working correctly to automatically return the
lever to the rope-locked position. Check movement is limited when the wheel is in the "REST" position. If necessary, clean it
with compressed air and lubricate with a silicon-based oil spray, according to the device's instructions for use.
• LOCKING WHEEL - Move the wheel on the two modes. Verify the absence of slack. The stroke of the wheel must not
overcome the two stops. If necessary, clean it with compressed air and lubricate with silicone-based oil spray, in accordance
with what indicated on the user's iunstructions of the device.
• LOCKING CAM - Check the cam can move freely and without sticking. If necessary, clean it with compressed air and lubricate
with a silicon-based oil spray, according to the device's instructions for use. Important! If the cam is seized or doesn't move
freely, the device will not lock on the rope, risk of death.
3.2 CHECKING DEVICE MOVES FREELY ON ROPE
Attach the device to a suitable-diameter rope fixed an anchor point. With the wheel in "GO" mode, move the fall arrester first up
the rope then down it to make sure that it slides freely. In "REST" mode it should slide in both directions with slight friction on the
rope and when released should stay in position. This check must be carried out using the rope recommended in the instructions for
use of the equipment.
3.3 CHECKING LOCKING
With the fall arrester attached to the rope from the previous test (if there is no connector, insert a compatible connector into the
connector hole) pull the device sharply downwards to make sure it immediately and effectively locks on the rope. Unlocking the
device is only possible when you unload it. This check must be carried out using the rope recommended in the instructions for use
of the equipment.
The examiner's verdict on the severity of the anomaly must be based on objective criteria and the specific training received.
The producer accepts no responsibility deriving from inexact information recorded by the user or servicer.
PRO22-2F713CTEN_rev.7 09-19
PERIODIC CHECKING OF
PERSONAL PROTECTIVE EQUIPMENT
FALL ARREST DEVICES COMPARABLE TO EASY MOVE