Installation - Wolf IR30450/S/T Guia De Instalacion

Installation

Preparation
Before moving the range, protect any finished flooring and
secure the oven door closed to prevent damage.
OVEN DOOR REMOVAL
To lighten the load or to fit through a doorway, the oven
door can be removed. Remove only if necessary. Door
removal should be done only by a certified installer or
service technician. Do not lift or carry the oven door by the
door handle.
To remove, open the door completely. Rotate both hinge
locks forward to the open position, remove the screw
closest to the hinge on both sides of the door, and pull the
door forward. Refer to the illustration below.
To reinstall, slide the door onto the hinges. Rotate the
hinge locks back completely and install the screws.
SCREW
HINGE
LOCK
Oven door removal
Placement
The range has rear casters which allow for easy movement
by lifting the front of the unit. Do not lift or carry the range
by the oven door handle.
Use an appliance dolly to move the range near the open-
ing. Place the appliance dolly on the side or back to pre-
vent damage. Remove and recycle packing materials. Do
not discard the anti-tip bracket supplied with the range.
Leveling
Raise the range to its desired height by adjusting the front
legs and rear casters. Use a 3/4" socket to adjust the rear
casters. The front legs can be adjusted by rotating the leg
clockwise to raise and counterclockwise to lower.
wolfappliance.com | 7