sunjoe SPX2599-MAX Manual Del Operador página 11

To connect a nozzle to the spray wand:
1. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
2. Engage the safety lock on the trigger handle.
3. Pull back the brass Quick-Connect collar and insert the
desired nozzle into the collar. Release the collar and the
nozzle will click into place (Fig. 17).
Fig. 17
Spray wand quick-
connect collar
Nozzle
To disconnect a nozzle from the spray wand once the cleaning
job is complete:
1. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
2. Engage the safety lock on the trigger handle.
3. Remove the nozzle by disconnecting it while pulling back
the brass Quick-Connect collar.
m
WARNING!
Do not make changes to the nozzle while
the trigger is engaged. Doing so could result in damage to the
pressure washer or injury to the user.
Working with Detergents
When cleaning with the pressure washer, some cleaning tasks
can be solved with water alone, but for most tasks cleaning
with detergent allows for more effective dirt removal.
m
WARNING!
Use only detergents specifically designed
for use with pressure washers, such as Sun Joe
DECK WASH (SPX-HDC1G), Sun Joe
WASH (SPX-FCS1G), or Sun Joe
(SPX-APC1G). DO NOT USE household detergents, acids,
alkaline solutions, bleaches, solvents, flammable material,
or industrial grade solutions. These could damage the
pressure washer. Many detergents may require mixing prior
to use. Prepare the cleaning solution as instructed on the
solution bottle.
1. Gently pull the foam cannon bottle out of its storage
position (Fig. 18).
HOUSE +
®
SNOW FOAM AUTO
®
HEAVY DUTY CLEANER
®
Fig. 18
2. Remove the cap. Fill the bottle or mix as recommended by
detergent instructions (Fig. 19), and secure the cap back
into place. Replace it back on the unit.
Fig. 19
3. Disconnect the spray wand from the trigger gun by
pressing it in firmly and twisting clockwise until the 2
wings of the spray wand can be removed from the slot
(Fig. 20).
Fig. 20
4. To connect the foam cannon with the trigger gun,
press the wings of the foam cannon into the slot of the
trigger gun, then twist counterclockwise until the 2 parts
are completely locked (Fig. 21).
11
Foam cannon
bottle
Detergent
for pressure
washer
Foam cannon
bottle