Aqua Marina LAXO Guía De Usuario página 8

HIGH PRESSURE VALVE
INFLATE THE KAYAK
Inflate the side chambers and air floor in sequence as shown in the picture.
1. Attach the pump hose to the pump and secure it tightly.
2. BOSTON VLAVE (FOR LAXO)
Ensure that the main valve is securely screwed into the ring plate first.
Open the upper cap of the Boston valve for inflation.
In this situation, the valve only lets air in, not out.
HIGH PRESSURE VALVE (FOR MEMBA)
Unscrew the valve cap, push button in and turn it
clockwise to make sure that the valve is in the
"Pin Out" position.
3. Start pumping air into the kayak. Keep inflating
until the required air pressure is reached. DO NOT OVERFILL. Once inflated, firmly cap
each valve.
TIP: If the pump piston starts to squeak, apply some lubrication oil on the piston shaft.
TIP: Working pressure of each part should NOT exceed the maximum as below.
LAXO
MEMBA
NOTE：After multiple times of inflation – deflation, there may be slight displacement of
the valve. Replace it to the correct position when deflated. Then inflate to required air
pressure to use.
SIDE CHAMBERS
1 psi / 0.07 bar
1 psi / 0.07 bar
8
Step 2
Step 1
BOSTON VLAVE
FLOOR
1 psi / 0.07 bar
4.35 psi / 0.3 bar
Upper cap
Main valve
Ring plate