Himsa NOAHlink Manual Del Usuario página 23

NOAHlink Users Manual
 Switch on your NOAHlink by pressing the button at the
COMMUNICATING
20
front of the unit until the middle light displays. A self-test
occurs every time you do this. The following table explains
the different LED (light-emitting diode) displays that may
occur during the self-test, depending on the power status of
the battery:
POWER STATUS
OK
Low (battery low)
Error
Once the self-test has been completed, your NOAHlink will
display different LEDs depending on:

the power status

whether the unit is communicating with your PC
The following table outlines the different possibilities:
WITH PC
Yes
No
LED DISPLAY
Continuous green light for
five seconds
Flashing yellow/orange light
for five seconds
Flashing red light for 30
seconds, then NOAHlink
powers off
POWER STATUS
OK
Low (battery low)
OK
Low (battery low)
LED DISPLAY
Quickly flashing green
light
Quickly flashing
yellow/orange light
Flashing green light
every three seconds
Flashing yellow/orange
light every three seconds