COZY CDV155DPPD Instrucciones De Instalación Y Funcionamiento página 17

STEP 6.
Right Side Install
WARNING:
Ensure wires
do not touch
combustion
chamber.
OR :
Left Side Install
WARNING:
Ensure wires
do not touch
combustion
chamber.
NOTE: If using Blower Kit DVB3 - Attach the wires to the Blower Shield.
INSTALLATION (CDV255DPPD and CDV305DPPD)
A. Connect the orange
sparker wire and
black sensor wire to
the lower heat shield
with a cable tie (64)
directly below the
burner sight glass.
B
16"
A. Bundle wires B. Allow the free ends of wires to
together and
pull toward the
left side of
the unit.
A
B
B. Route the orange
and black wires over
to the wiring harness
(connected to the
valve).
C
extend approximately 16" from
the edge of the heat shield.
Connect the wires to the left
side of the lower heat shield with
a cable tie (64).
Page 17
C. Allow the free ends of
the wires extend approx-
imately 6" from the rear
of the valve bracket.
Bundle and secure the
wires to the valve bracket
with two cable ties (64)
as illustrated.
A
C. Secure the
hanging wires to
lower heat shield
(directly below
burner sight glass)
with a cable tie (64).
C
6"
1019068-C