Troubleshooting - Yamaha CD-S1000 Manual De Instrucciones

Refer to the chart below if this unit does not function properly. If the problem you are experiencing is not listed below or
if the instructions below do not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.
Problem
The power cable is not connected to the AC IN
This unit fails to turn
inlet on the rear panel or not plugged in the AC
on.
wall outlet.
A foreign object is obstructing the tray.
The disc tray does not
close completely.
The disc is damaged.
Playback does not
start.
There is moisture on the laser pickup.
The disc is loaded upside down.
The disc is dirty.
The MP3 or WMA formats are not compatible
with this unit.
The CD-RW (ReWritable) disc is not recorded
correctly.
The disc is a non-standard disc not playable with
this unit.
The disc may be scratched or damaged.
Playback is delayed,
or begins at the
wrong place.
Improper output cable connections.
No sound.
Improper amplifier operation.
PURE DIRECT is turned on.
Sound of a
component
connected to the
Super Audio CD layer is playing.
DIGITAL OUT jacks is
not played.
This unit is being subjected to vibrations or
Sound "skips".
impacts.
The disc is dirty.
Improper cable connections.
Sound "hums".
The tuner is too close to this unit.
Noise from a nearby
tuner.
The disc may be warped.
Noise from inside of
the disc tray.
Cause
Connect the power cable firmly.
Carefully check the disc tray and remove the
foreign object.
Check the disc carefully; replace it if necessary.
Wait 20 to 30 minutes after switching on the unit
ON before trying to play back a disc.
Reload the disc with the label side up.
Clean the disc.
Replace the disc with a correctly recorded disc
playable with this unit.
Replace the disc with a correctly recorded disc
playable with this unit.
Replace the disc with a correctly recorded disc
playable with this unit.
Check the disc carefully; replace it if necessary.
Connect the cables properly. If the problem
persists, the cables may be defective.
Set the amplifier controls to the correct input
selection.
Turn PURE DIRECT off. Or make an analog
connection.
Switch the playback layer. Or make an analog
connection.
Relocate this unit.
Clean the disc.
Securely connect the audio cables. If the problem
persists, the cables may be defective.
Move the tuner and this unit farther apart.
Replace the disc.

Troubleshooting

Remedy
See
page
15
—
—
—
—
20
20
19
19
20
14
—
6
6, 10
—
20
14
—
—
21
En