Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING – POSSIBLE RISK OF INJURY TO EYES AND SKIN
Hazardous optical UV, HEV, and IR radiation may be emitted from the
light source. Always wear personal protective equipment ensuring
complete shielding of skin and eyes. Avoid prolonged exposure and
looking directly at light source.
WARNINGS
Please read these installation instruction carefully and keep it on hand. Before installing,
servicing, or performing routine maintenance, follow these general precautions:
•
For the installation: if you are unsure about the installation or maintenance of this
fixture, consult a qualified licensed electrician and check your local electrical code.
•
Do not make or alter any open holes in an enclosure of wiring or electrical components
during kit installation.
•
Turn off the power and unplug fixture when you perform any maintenance or cleaning
activity.
•
Verify that supply voltage is correct by comparing it with the information on spec label.
•
Avoid hitting, bending or causing mechanical stress to the fixture.
•
DO NOT cover or block any part of the fixture during operation.
•
To ensure optimal performance, the back of the lighting panels may require periodic
cleaning. Clean with compressed air or damp lint free cloth.
•
12" Clearance must be maintained from any combustible surface.
•
Always provide a well-ventilated environment where ambient temperatures do not
exceed 40°C (104°F) regardless of whether the fixtures are in operation or off. Excessive
temperatures can inhibit performance and may cause damage or shorten the life of the
fixtures and void the warranty.
•
Do not run or store fixtures in the facility unless proper environmental cooling
systems are in operation. Facilities that are "shut down" can record excessively high
temperatures resulting in premature equipment failure.
•
When calculating cooling needs for your facility, take into consideration BTU load
generated by LED fixtures.
•
This IP 65 LED fixture is intended for indoor use only. Avoid high pressure jets of water.
•
Do not expose the fixture to the sulfur dioxide compound. If sulfur application is part of
your practice, please make sure to remove the fixtures prior to this process.
Additional safety warnings:
•
Cables shall not be concealed or extended through a wall, floor, ceiling, or other parts of
the building structure.
•
Cables shall not be located above a suspended ceiling or dropped ceiling; permanently
affixed to the building structure.
4
www.phantombio.com
USER MANUAL
Publicidad
Tabla de contenido
