Phantom PHOTOBIO-MX Manual Del Usuario página 5

• Cables shall be routed so that they are not subject to strain and are protected from
physical damage; and visible over their entire length.
• Cables shall be used within their rated ampacity as determined for the maximum
temperature of the installed environment specified in the instructions.
• This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
• CAN ICES-3(B)/NMB-3(B)
INSTALLATION
Before you start the installation, make sure to address the following: This fixture
installation requires 2 people, a flat, clean and soft surface of at least 4'x4' (e.g.: blanket,
foam...etc).
Be sure that the fixture is unplugged from the power source before installation.
PHOTOBIO•MX driver is designed to be mounted either attached to the fixture or mounted
remotely. To attach the driver on the fixture follow the steps below:
Type A: Attaching the driver to light fixtures
Step 1.
a. Take out the lighting fixture (Part A) and driver (Part B) out of box separately with care,
as Fig. 1.
b. Use allen key (Part D) to loosen hinge hole B on both hinges, as Fig. 2.
Fig. 1
Fig. 2
USER MANUAL
Hinge Hole A
Hinge Hole B
5
TM