Energy Saving Tips; Before Starting - Danby DPF073C1WDB Guía De Utilización Y Cuidado Para El Propietario

Refrigerador libre de escarcha parcial
Ocultar thumbs Ver también para DPF073C1WDB:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS

ENERGY SAVING TIPS

Try not to open the door too often, especially when the weather is hot and humid. Once you open the door, close it as
soon as possible.
Every now and then check if the appliance is suffi ciently ventilated (adequate air circulation behind the appliance).
Set the thermostat from cooler to warmer settings whenever possible (depending on how loaded the appliance is,
ambient temperatures etc.).
Before loading the appliance with packages of hot food, make sure that they are cooled to ambient temperature.
Ice and frost layers increase energy consumption, so defrost the appliance as soon as the frost layer is 1/4 inch / 3-5
mm thick.
If the gasket is damaged or the door seal is poor, energy consumption is substantially higher. To restore effi ciency,
replace the gasket.
Always follow instructions stated in this manual.
DISPOSING OF YOUR OLD APPLIANCE
The refrigerator system of the appliance is fi lled with refrigerant and insulating substances which should be separately
treated and processed. Call your nearest authorized service agent or specialized servicing centre. If you are unable to
locate one, contact your local authorities or your distributor. Be careful not to damage the tubes on the rear wall of the
appliance.

BEFORE STARTING

To avoid vibration, the unit must be set level. This is accomplished by adjusting the front leveling leg, located under
the refrigerator.
Before connecting this appliance to electrical power supply, leave it to stand for approximately 24 hours, which will
reduce the possibility of malfunction in the cooling system due to transport handling.
This unit is not designed for outside installation, including installation anywhere that is not temperature controlled
(including garages, porches, carports, etc.).
If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes before restarting the unit. If you
attempt to restart before this time delay, the refrigerator-freezer will not start.
SAVE THESE INSTRUCTIONS!
3

Publicidad

Tabla de contenido
loading

Tabla de contenido