Descargar Imprimir esta página

Mechanical Assembly - Homak security HS30136010 Guía De Utilización Y Directivas De Funcionamiento

Publicidad

Idiomas disponibles

Idiomas disponibles

Mechanical Assembly

Inside the Cabinet Door you will find the following
items:
- Wall Mounting Kit
- Five Shelves
- Barrel Rest Kit
1. Installing The Cabinet
Locate the four washers and screws located
in the wall mounting kit that is included with
this Cabinet. Place the Cabinet in a suitable
location. Using the screws and washers
provided, locate the mounting holes and
fasten the cabinet to the wall. The cabinet
holes are 16 inches apart
NOTE: This Cabinet is NOT designed to
be used without securing it to a wall or
other surface. IT MAY TIP OVER!
2. Installing The Shelves
When installing the shelves, first locate the shelf support
clips. Push each clip into place by sliding the back of the
clip down into the mounting hole on the side walls inside the
cabinet. Make sure to count down the number of holes in the
guide strip so that each shelf is level and properly supported.
Place the shelf onto the shelf clips and push down to ensure
they are properly installed.
- Foam Components
- Lock Key Set
Mounting
Holes
Back of
Cabinet

Publicidad

loading