Descargar Imprimir esta página

Homak security HS30136010 Guía De Utilización Y Directivas De Funcionamiento página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

side walls very neatly and without air bubbles. Repeat this
technique on the opposite side.
3. Remove the paper from the barrel rest mounting bar
(J) and place directly above the foam insert (D), that was
applied in step 2.
4. Place Bottom foam pad (B) into bottom floor of the unit.
5. Remove adhesive and place the Shelf foam (A) onto the 2
adjustable shelves in the back of the cabinet.
NOTE: Attaching the foam to the shelves is easily
done by removing the shelves from the cabinet, once
installed, and applying the foam. Once foam is applied
replace the shelf back inside the cabinet.
Barrel Rest Installation
1. After the Barrel rest mounting bar has been attached
during the Foam installation instructions, you may slide the
barrel rests onto the mount bar in any position. The barrel
rests are designed to slide in and out of the mounting bar.
They can be moved at any time. See illustration below for
reference.

Publicidad

loading