Important Safety Instructions; Installation; Rackmount Installation - Tripp-Lite PDU Manual Del Usuario

Regletas de contacto para montaje en bastidor
Ocultar thumbs Ver también para PDU:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Important Safety Instructions

This manual contains information concerning the proper installation
and use of Tripp Lite's Rackmount Power Strips.
SAVE THESE INSTRUCTIONS.
Do not connect your power strip to an ungrounded outlet. Do not use it with extension
cords or adapters that eliminate its connection to ground. Your power strip is designed
for indoor use only. Install it away from heat emitting devices such as radiators and heat
registers. Do not install where excessive moisture or other conductive contaminants are
present. Never install electrical wiring during a lightning storm.
The power requirement of each device connected to an outlet of your power strip must
not exceed the Outlet Power Rating of your power strip (see Specifications). The total
power requirements of all devices connected to your power strip must not exceed the
Maximum Load Rating of your power strip (see Specifications).
CAUTION
Only those who are properly trained or qualified to use this device should
do so. Anyone who is not trained or qualified should not use this device unless it is
under the supervision of someone who is properly trained or qualified to do so.
Children must be supervised to ensure that they do not use the device as a toy.
Never use the device if the cord and plug are damaged; if it is not working properly,
or if it has been dropped or damaged, take it to an authorized service center for
inspection and repair.
If the power cord is damaged, it must be replaced by the manufacturer, its authorized
service agent, or by qualified personnel in order to avoid a danger.

Installation

1U Rackmount Installation
To Mount Unit in Rack: Put four user-supplied
rackmount screws (A) through the unit's mounting
ears (B) and into the rack rails as shown. The user
must determine the fitness of the rackmount screws to
hold the unit in the rack before installation.
0U Rackmount Installation
1. Reorient Mounting Ears: Unscrew the screws (A)
holding the unit's mounting ears (B) to the sides of
the unit. Use the screws from Step 1 (A) to reattach
the mounting ears (B) to the unit as shown. Use
only the manufacturer-supplied screws or their
equivalent (#6-32, ¼" flat head) to reattach the
mounting ears.
2. Mount Unit on Outside of Rack Rails: Put four
user-supplied screws (C) or similar mounting
hardware through the unit's mounting ears (B) and
into the side of the rack as shown. The user must
determine the fitness of the user-supplied mounting
hardware to support the unit before mounting.
21-03-383-932120.indb 2
21-03-383-932120.indb 2
1U Rackmount Installation
2
0U Rackmount Installation
4/1/2021 11:00:33 AM
4/1/2021 11:00:33 AM

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ag-ip120v6iprmAg-ip120v20rmAg-ip120v6iprm serieAg-ip120v20rm seriePdu1215Pdu1220 ... Mostrar todo

Tabla de contenido