Light Bulb Replacement - Kenmore 116.35922 Manual Del Propietário

IbWARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
performing maintenance to the unit.
Failure to do so could result in
electrical shock or personal injury
from the vacuum cleaner suddenly
starting.
TO REMOVE LIGHT BULB
1. Disconnect power cord from electrical
outlet.
Flat
Screwdriver
Headlight
Lena
2. Press han-
dle release
pedal and lay
vacuum clean-
er
back,
3. Pry light
lens out at
slots as shown
on both sides.
Rotate lens up
and lift off.
CAUTION
Do not use a bulb rated over 9W (13V).
During extended use, heat from the
bulb could overheat surrounding plas-
tic parts.
4. Remove the light bulb
by pulling straight out.
5. To replace the light
bulb carefully insert
fully into slot.
Note: See PARTS AND FEATURES for
bulb number.
I&O.OT,O. I
Do not plug in or turn on until the vacu-
um cleaner is completely reassembled, I
6. To replace light ._,_:/j
lens, place tab at front --.-..._ _'_L._
of lens into slot. Rotate
lens down and firmly __ ,' '
snap into place, i
18