Important; Agitator Assembly; Light Bulb Changing - Kenmore 125.22614610 Manual De Uso

TO CLEAN AGITATOR:
NOTE: In order to keep cleDQLQJ HèFLHQF\
high and to prevent damage to your vacuum
cleaner, the agitator must be cleaned every
time the belt is changed.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Cleaner Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
WARNING
Electrical Shock Or Personal Injury
Hazard
TXUQ Rç DQG XQSOXJ vacuum cleaner
before performing maintenance to the
vacuum cleaner. Failure to do so could
result in electrical shock or personal
injury from the vacuum cleaner
suddenly starting.
CAUTION
Do not plug in or turn on until the vacuum
cleaner is completely reassembled.
1. Remove PowerMate
BELT CHANGING AND AGITATOR
CLEANING (pages 21-22).
Pull out to
left side
Clean Agitator
every week
every month
every 2 months

LIGHT BULB CHANGING

®
cover as shown in
2. Remove the light
bulb by pulling
straight out.

IMPORTANT

TXUQ Rç DQG XQSOXJ vacuum cleaner from
electrical outlet. Check and remove hair,
string and lint build-up frequently in the
®
PowerMate agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris lo-
cated on the agitator or end caps.

AGITATOR ASSEMBLY

End Cap
CAUTION
Do not use a bulb rated over 9W (13V).
During extended use, heat from the bulb
could overheat surrounding plastic parts.
Push in
to right
4. Reinstall PowerMate
BELT CHANGING AND AGITATOR
CLEANING (pages 21-22).
NOTE: See PARTS AND FEATURES (page 5)
for Bulb number.
- 22 -
Belt Path
Brush Unit
End Cap
3. To replace the
light bulb,
carefully insert
fully into slot.
®
cover as shown in