Technical Data; Charge The Battery - Würth RL1-18 Traducción Del Manual De Instrucciones De Servicio Original

Technical data

Art.
Accuracy
Working range
Level indication accuracy ± 4°
Speed of rotation
Laser type
Laser classification
Operating temperature
Storage temperature
Protection class
Operating time

Charge the battery

Note
If the battery capacity falls below 15 %,
the operating indicator [4] goes red.
Charge the batteries (charging socket [8] is at
■
the bottom on the side of the device).
Note
You can exchange battery power packs
for charged battery power packs or use
non-rechargeable batteries.
3 During charging the charging socket LED
illuminates.
Start-up (Fig. I)
Protect the device against moisture
■
and direct sunlight.
Do not expose to extreme tempera-
■
tures or temperature changes.
E.g. do not leave it in a car for longer periods of
■
time. Before using, allow the device to acclima-
tise if has been exposed to high temperature
changes. Extreme temperatures or temperature
changes can impair the accuracy of the device.
Protect the device against hard shocks
■
or drops.
After heavy impacts, always check
■
the device for accuracy before using it
again.
12
5709 300 301
± 0.75 mm over 10 m
450 m diameter
800, 450, 2000 rpm
635 nm
2
-10°C to +45°C
-20°C to +70°C
IP55
Approx. 30 h
Switch ON
Place the device on level ground.
■
Press the on/off button [13] to switch the device
■
on.
3 The mode indicator [1] remains green once
levelling has ended.
3 The laser beam rotates.
3 If levelling is not possible, the ALARM indica-
tor [12] flashes.
If this occurs, ensure the device is horizontal.
■
Button for manual, automatic or ADS
mode [3]
1x: ADS mode off:
■
3 The device is self-levelling.
2x: Manual mode.
■
3 No levelling.
X-axis inclination is possible using the but-
■
tons [2] and [11]. The ALARM indicator [12]
goes red. Y-axis inclination is only possible with
the optional remote control.
3x: automatic mode.
■
3 Automatic levelling and activation of ADS.
Button for rotation speed and scan-
ning mode [10]
Quick press: Change the rotation speed be-
■
tween 800, 450 and 2000 rpm
Long press: Change to scanning mode.
■
Thereafter press quickly to change the scanning
■
angle (10, 45, 90°).
Using buttons [2] and [11] the scanning beam
■
can be rotated in both clockwise and anticlock-
wise directions.
The laser is switched off with a long button press
■
(> 3 seconds) on the on/off button [13].