Problem Solution - Worx WA3835 Manual Del Usuario

but should not be expected to perform as much
work as new battery packs.
IMPORTANT CHARGING NOTES:
1. For a new battery or a battery that has been
in storage for sometime, please recharge the
battery before use. If you want to store the
battery for a long time, please fully charge
the battery pack to ensure maximum battery
life.
2. Longer life and better performance can
be obtained if the battery pack is charged
when the air temperature is between (18-
24ºC). Do not charge the battery pack in air
temperatures below 4.5ºC, or above 40.5ºC.
This is important as it can prevent serious
damage to the battery pack.
3. Never freeze your charger or immerse
charger in water or any other liquid.
4. When the battery pack fails to produce
sufficient power on jobs that were
previously done easily, please recharge your
battery, do not continue to use under this
condition. You may charge a partially used
pack whenever you desire with no adverse
affect on the battery pack.
5. When charging it is normal that the charger
and battery pack may become warm to
touch.
6. If the battery pack does not charge properly:
a. Check current at power outlet by plugging in
another appliance.
b. Plug and unplug to check whether the
charger is ok.
c. Check whether the battery has been
damaged
d. Move the charger and battery pack to
a location where the surrounding air
temperature is approximately 18-24ºC.
e. If the charging problem persists, take
the tool, battery pack and charger to an
authorized service center.
f. Under certain conditions, when the
charger is plugged into the power supply,
the exposed charging contacts inside the
charger can be shorted by foreign material.
Foreign materials of a conductive nature
such as metallic particles should be kept
away from charger cavities. Always unplug
the charger from the power supply when
Battery Charger
there is no battery pack in the charger or
before attempting to clean.
4. TO REMOVE OR INSTALL BATTERY
PACK
Depress the Battery Pack Release Button to
remove the Battery Pack from your tool. After
recharging, insert the battery pack into the
battery port. A simple push and slight pressure
will be sufficient.

PROBLEM SOLUTION

1. I CANNOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
a) Check if the charger and the battery pack
are specifically designed for working
together.
b) The battery can be inserted into the
charger only in one direction. Turn the
battery around until it can be inserted into
the slot, the indicator light should be green
and flash when the battery is charging.
2. REASONS FOR DIFFERENT CHARGING
TIMES
The charging time can be affected by many
reasons which are not defects in your product.
a) If the battery pack is only partly discharged
it may be re-charged in less than
rated charging time (WA3525:25min
WA3520:17min).
b) If the battery pack and ambient
temperature are very cold/ hot, it may
take longer to re-charge. Please find an
appropriate environment with proper air
temperature to start charging.
c) If the battery pack is very hot, remove
battery pack from the charger and allow
battery pack to cool first to ambient
temperature and then recharging can be
started.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your battery charger requires no additional
lubrication or maintenance. Never use water
7
EN