Cd Operation - auna Julie Ann Manual Del Usuario

Recording function
1. While listening to PHONO/TAPE/CD/BT/AUX IN, press RECORD.
2. Press RECORD again to confirm. During recording, the "USB" digit at the
right top of the LCD will keep flashing until the recording is finished.
*NOTE that the encoding speed is 1:1.
3. Press STOP to stop recording.
4. The unit will create a folder in the USB device, that contain all recorded
tracks.
Deleting recorded track or files
In USB playing mode, press the DELETE button on the remote control twice
to delete the playing track.
Radio operation
1. Press the POWER button on the front panel to turn the system 'on' and
set the volume to a low level. Press FUNCTION button and enter FM
mode.
2. Rotate the TUNING control to tune the desired radio station.
3. When you finished listening, press the POWER button again to turn the
system off. The display backlight goes 'off'.
Fm operation
The FM antenna is located on the back cabinet. If necessary adjust the
position and direction of this antenna for the best reception.

CD OPERATION

1. Press the FUNCTION button and enter CD mode. The unit can play CD,
CD-R and CD-RW.
2. Press the OPEN/CLOSE button to open the CD drawer
3. Place your disc(MP3 is compatible) in the CD drawer with the label side
facing up.
4. Press the OPEN/CLOSE button again to close the CD drawer. The disc
will spin for a few seconds while the player is reading the disc, then the
disc stops spinning and start to play the first track of the disc.
EN
37