BIG ASS FANS Powerfoil X3.0 Guía De Instalación Rápida página 2

1. MAIN FAN UNIT
New Fan Installation: Complete all necessary pre-installation and mounting structure preparation steps in the instructions
included with the main fan unit. Mount the fan by completing steps 1–5 in the fan Quick Installation Guide included with
the main fan unit. Do not complete the remaining steps. Return to these instructions to complete the fan installation.
Fan is Already Installed: Remove the hub cover. If the Airfoil Restraint System is installed, detach the straps from the hub.
Remove the airfoils and winglets. For Powerfoil D, detach the lower safety cables from the extension tube. For Powerfoil
Breeze, detach the lower safety cables from the extension tube and remove the fan's outer panels.
2A. STATIC TUBE POWERFOIL X3.0, POWERFOIL X2.0
Retainer Clip*
*Retainer clip is pre-installed to static tube. Remove clip from
static tube before installing tube into fan, and then reinstall clip
at top of tube.
2B. STATIC TUBE POWERFOIL D, POWERFOIL BREEZE
35 ft·lb (47.4 N·m)
Kit 009894-02-011
Motor Frame Weld Nut
7/8"
(22 mm)
35 ft·lb (47.4 N·m)
Kit 009894-01-011
or 009867-011
Retainer Clip*
7/8"
(22 mm)
FANS WITHOUT A MOTOR FRAME WELD NUT
If your motor frame does
NOT have a weld nut, see the
instructions and use the static
tube marked "PFX-R" provided
in kit 009867-011.
FANS THAT ALREADY HAVE A STATIC TUBE
If your fan already has a fi eld-installed (removable) static tube,
uninstall the static tube, bracket, and clamp. Replace with the
static tube marked "PFX-R" provided in kit 009867-011. See
the instructions included in the kit for installation details.
If your fan already has a factory-installed (non-removable)
static tube, skip to step 3.
Replace with
kit 009867-011
Motor Frame Weld Nut
*Retainer clip is pre-installed to static
tube. Remove clip from static tube
before installing tube into fan, and
then reinstall clip at top of tube.