Storage And Cleaning - Cooper COOLER HC01 Manual De Instrucciones

Cooper Cooler - Model HC01
When you are finished using your Cooper Cooler follow these
steps for storage.
1. Remove any beverages from inside the unit.
2. Remove all water and ice from the ice water bin. To remove
the ice and water for storage, select the CAN+ NO SPIN set-
ting, then place a cup under the water exit jet and press the
START/STOP button. When the cup is full, press the START/
STOP button again and discard the water. Continue this pro-
cess until no more water is flowing from the water exit jet.
There will still be a small amount of water in the ice water bin.
To remove this water, first unplug the unit, then rock the unit
front to back to remove any water caught in the pump system.
Carefully pour the water into your sink over the side of the unit
and not over the touchpad timer. Avoid getting the touch pa
timer wet. Always remember to remove the water when you
are finished with the unit. Do not allow water to sit in the
Cooper Cooler for extended periods of time.
3. Allow the unit to air dry with the lid up.
4. Store the unit in a safe place out of the reach of children.

Storage and Cleaning

If the inside of the unit is dirty, clean with mild lukewarm soapy
water as detailed below.
5. Pour two cups of lukewarm soapy water into the ice water bin.
6. Plug in the unit and close the lid. Choose the CAN + NO SPIN
setting and let the soapy water circulate in the machine.
Follow the water removal instructions on the left to remove the
soapy water.
7. Pour twp cups of regular tap water into the ice water bin.
8. Put down the lid. Rinse the unit with the tap water. Choose the
CAN + NO SPIN setting and let the tap water circulate in the
machine. Follow the water removal instructions on the left to
remove the soapy water.
9. Unplug the unit and allow to air dry.
Please note: Do not use abrasive powders or scouring pads since
they may scratch the surface of your Cooper Cooler.
12