Ratio Pro Serie Manual De Instrucciones página 43

OPERATING INSTR
UCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for driving in and
loosening screws as well as for drilling in wood,
metal, plastic, masonry and concrete.
BEFORE PUTTING INTO OPERATION
CHARGING THE BATTERY PACK
NOTE:
a) Do not use any charger other than that
specifically provided for use with the
equipment.
b) If the battery pack is very hot you must
remove your battery pack from the
charger and allow time for the battery to
cool down before recharging.
c) The battery in your new tool is not
charged when it leaves the plant.
Therefore it must be full charged before
using the first time.
d) Please charge the battery to reach full or
no less than half charge before storage. If
the tool will not be used for long periods
of time, charge the battery every 3-6
months.
CHARGING PROCEDURE (SEE FIG. A)
1) Plug the charger into an appropriate
outlet. The light will be green.
2) Slide the battery pack into the charger,
make sure the battery is in the correct
charge position firmly. the light will turn
to red to indicate the charging process
has started.
3) When charging is completed, the light will
turn to green.
4) After fully charged, unplug the charger
and remove the battery pack.
Note: If the battery pack is locked in the
charger, press the battery pack release
button and remove it.
CHARGING INDICATOR
This charger is designed to detect some
problems that can arise with battery packs.
Indicator lights indicate problems (see table
below). If this occurs, insert a new battery
pack to determine if the charger is OK. If the new
battery charges correctly, then the original pack
is defective and should be returned to a service
center or recycling service center. If the new
battery pack displays the same problem
as the original battery pack, have the charger
tested at an authorized service center.
Light ON/OFF
flash
Red on
Red flash - - - -
Green on
Green flash - - - -
WARNING: When battery charge runs
out after continuous use or exposure
to direct sunlight or heat, allow time for the
battery to cool down before re-charging to
achieve the full charge.
A
OPERATION
1. INSTALLING AND REMOVING THE
BATTERY PACK
a) To remove the battery pack (see fig. B1)
Depress the battery pack release button
firmly first and then slide the battery pack out
from your tool.
b) To install the battery pack (see fig. B2)
Slide the fully charged battery pack onto the
tool with sufficient force until it clicks into
position.
Status
Charging
Defective Bat-
tery
Fully Charged
Hot/Cold Delay
43