Care Of Drain Air Gap - IKEA LAGAN Manual De Usuario

EN

Care of Drain Air Gap

If a drain air gap was installed for your
built-in dishwasher, check to make
sure it is clean so the dishwasher will
drain properly. A drain air gap is usually
mounted on countertop and can be
inspected by removing the cover. This is
not part of your dishwasher and is not
covered by warranty.
Winterizing
A dishwasher left in an unheated place
should be protected from freezing. Have
a qualified person do the following:
To Disconnect Service:
1. Turn off electrical power to the
dishwasher at the supply source by
removing fuses or tripping circuit
breaker.
2. Shut off water supply
3. Place a pan under the inlet valve.
Disconnect water line from inlet
valve and drain into pan.
4. Disconnect drain line from pump and
drain water into pan.
To Restore Service:
1. Reconnect the water, drain, and
electrical power supply.
2. Turn on water and electrical power
supply
3. Fill both detergent cups and run
dishwasher through a HEAVY WASH
cycle.
NOTE
See Installation Instructions for more
details on disconnecting and restoring
service to your dishwasher.
CARE AND CLEANING
15