Product Specifications - Homewerks WORLDWIDE 3310-250-RB-B Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PRODUCT SPECIFICATIONS

SPECIFICATIONS
Max. flow rate of aerator: 2.2 GPM (8.3 LPM) at 60 PSI
Max. flow rate of hose end: 4.0 GPM (15.1 LPM) at 20 PSI
ASME A112.18.1/CSA B125
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve
under the sink or at the main
water supply, disconnect the
supply line, and remove old
faucet.
Clean and dry surface area
where new faucet will be
mounted.
2. Mount the faucet to the laundry sink either directly or using a mounting
block (not included).
The two (2) mounting tabs should face the FRONT of the laundry tub
(over the basin), the single tab should face the rear of the basin.
3. Attach the supply lines to the
faucet. Cold to the right side, hot to
the left.
Slide the union nuts over the supply
lines.
Install the union tailpieces to each
supply line.
If soldering the supply lines, remove
the rubber O-rings from the union
tailpiece, solder, and replace when
cool. If threading, cover all male
threads with thread sealant tape
(wrapped clockwise), or pipe joint
compound. Attach firmly but do not
over tighten.
OPERATION INSTRUCTIONS
Instructions for changing hose thread aerator:
Turn off water at handles.
1. Use an adjustable pliers to grasp the aerator housing
while holding the spout with your other hand.
2. Rotate aerator to the left to loosen.
3. Remove aerator with fingers.
4. Thread hose aerator onto spout making sure washer is
in place.
5. Tighten hose aertor by turning aerator to the right while
holding the spout in place. Do not over tighten.
6. Turn water on at handles, faucet will work as normal
with the hose thread aerator in place.
Instructions for connecting hose:
Use a standard 3/4" hose thread connector to attach the
hose to the threaded aerator, making sure the hose
washer is in place. Tighten by turning the hose connector
to the right. Do not overtighten.
1
3
SPECIFICATIONS
1/4-turn drip-free cartridge
1/2" solder or female threaded inlets
Total weight of item: 1.87 lbs.
4. Turn water supply or shut off
valve back on and check for
leaks.
Remove aerator from spout.
Turn on faucet and run at least
30 seconds to flush out water
line. Turn off faucet and replace
aerator.
If leaking occurs you can tighten the hose aerator more.
When removing the hose make sure water is turned off at
the faucet and that you have allowed the hose to drain. On
a long hose some water may remain in the hose and drain
out when you remove the hose.
Instructions for use:
Adjust water to proper temperature by turning on the hot
and cold water valves. Swivel faucet spout as needed to
add and remove items from the laundry tub.
Do not hang items like pails or buckets from the spout.
2
4
REMOVE
AERATOR
www.homewerksww.com

Publicidad

Tabla de contenido
loading

Tabla de contenido