AVS Electronics LED Plus Serie Manual General De Instalación página 12

Installation
Opening of the siren
Remove the external
cover (main)
Fasten the flash covers to the
main cover of the TS85 P/V/X
LED Plus models
E
N
G
Installing the siren
Use the bottom of the siren to
prepare the 3 holes used to fasten
to the wall...
Use an 8mm point to make the
four holes
5
Putting into operation
1
2
1
4
On the TS85 P/V/X LED Plus models, remove the
spacer shown in the figure, in the CITY LED Plus
models, enter the supplied spacer, insert the plug
and tighten the screw making sure to maintain the
spacer in line with the bottom of the siren
7
1
During the starting up and subsequent maintenance, it is possible to place
the outer and inner lid (as shown in the figure) to the polycarbonate bottom.
3
Close the internal cover letting the tamper level and the 4 centring turrets
protrude from the holes prepared.
!!Warning!! Do not crush the internal wiring cables (FOAM, TAMPER, etc.)
when closing the cover.
4
Close the external cover
(main)
TS85 P/V/X LED
CITY PLUS LED
Fasten the bottom of the siren to the wall with the 3 plugs supplied
2
Prepare the connection to the control unit.
With the initial Block of the Cone and the Flash, it is possible to
connect the battery (max. 2.1 Ah) program the siren and carry
out the function tests without power supply from the control unit.
The TAMPER output is opened.
C e n t r i n g
turrets
- 12 -
3
3
Use the supplied bubble for the proper
positioning of the siren
2
... and that for
the Anti-removal
device
6
Turn the tamper in place, in
the TS85 P/V/X LED models,
at the spacer tamper and in
the version CITY LED Plus to
the fixing screw of the spacer
tamper.
TAMPERING
fastening the
internal cover
Remove the
internal cover
level
Holes for