Cleaning Instructions - Weston 07-3101-W-A Manual

CLEANING INSTRUCTIONS

1. Thoroughly wash all parts in soapy water. Rinse with clean water. Dry all parts
immediately. NOTE: DO NOT immerse the Blade Assembly in sudsy water where
they cannot be seen. To prevent injury, keep the Blade Assembly visible at all
times.
2. Coat all metal parts with a food grade silicone spray.
HELPFUL HINT: A long, skinny brush is helpful when cleaning the Blade
Assembly.
ASSEMBLY INSTRUCTIONS
w WARNING
1. Connect the Left and Right Legs
to the Base using the provided Allen
Wrench and 4 Base Screws and Lock
Washers. FIGURE A
2. Using an Allen Wrench and 4 Leg
Screws and Lock Washers, attach
the Left and Right Legs to the Lower
Housing. FIGURE A
3. Install the Chute to the Top
Housing using an Allen Wrench
and the 2 Chute Screws and Lock
Washers. FIGURE B
4. Insert the Blade Assembly into the
Lower Housing, guiding the Drive Shaft
into the journals. Make sure the gears
and the blades of the Blade Assembly
are properly meshed together and
resting in the journals (FIGURE C).
NOTE: The Tenderizer Blade is a
2-piece set. The Jerky Slicer Blade is a
single piece (sold separately).
6
Cut Hazard. Blades are sharp, use care when handling. The
use of cut-resistant gloves is suggested.
Leg Screws (4) &
Lock Washers (4)
Allen
Wrench
Legs
Base
Allen
Wrench
Chute
Top
Housing
Allen
Wrench
FIGURE A
Lower
Housing
Base Screws (4)
and Lock Washers (4)
FIGURE B
Chute Screws (2) &
Lock Washers (2)