Elite TS255 Manual De Usuario página 42

3. Pull out and turn the Height Handle (29) counterclockwise to raise the motor to its uppermost position.
4. Turn the Lock Knob (53) counterclockwise to loosen the tilt lock. Push the Height Handle in to engage
the gears and rotate it counterclockwise to tilt the Spindle to 15 degrees. See Figure 7.
5. With the Open-end Wrench (140), hold the Inner Flange (72) and use the other Open-end Wrench
(141) to loosen the Blade Nut (75). Then remove the Blade Nut and Outer Flange (74) and remove old
blade. See Figure 8, below.
WARNING! ONLY 10 IN. saw blades with a 5/8 IN. arbor, rated to at least 5,000 RPM with a 1/2 IN. kerf/-
dado or less and intended for woodcutting may be used with this Table Saw.
6. With the teeth at the top of the new Saw Blade pointing toward the front, place the Saw Blade over the
Spindle. Slide the Outer Flange over the Spindle (keeping the recessed face towards the Saw Blade.)
7. Attach the Blade Nut and finger-tighten. Then use the Wrenches, one to hold the Inner Flange and the
second to tighten the Nut.
CAUTION! Do not overtighten.
NOTE: The Spindle has a normal right-hand thread and is secured when turned in a clockwise direction.
8. Once the Blade is secured, adjust the Riving Knife and install the Blade Guard.
13
www.ELITETOOLS.co
Keep Working