Malfunctions; Technical Data - diversey TASKI ergodisc 165 Manual De Instrucciones

Malfunctions

Malfunction
Machine without function
Tool does not rotate
Machine has no function, indicator
light is on
Machine does not reach nominal
speed, overcurrent is activated
Machine does not run smoothly
Spray pump is running, cleaning
product is not released

Technical data

Machine
Working width
Dimensions (LxWxH)
Machine weight
Rated voltage
Frequency
Rated power, nominal
Rated power, additional outlet
Machine
Working width
Dimensions (LxWxH)
Machine weight
Rated voltage
Frequency
Rated power, nominal
Rated power, additional outlet
78
Possible causes
Machine is switched off
No power supply
Main cord defect
Motor does not turn
Defective safety switch
Motor runs, but tool does not rotate
Defective electronic component
Machine overload, overload switch
was activated
Machine overload
Undervoltage: Main cord is too long
Pad deformed or damaged
Cleaning product dried in the spray
unit or hose blocked
165
43
67 x 48 x 119
34
230-240V~
50
1100
700
175
43
67 x 48 x 119
34
120V~
60
1100
700
Troubleshooting
• Switch on the main switch
• Insert the plug into the mains sock-
et
• Replace the main cord
• Contact your service partner
• Contact your service partner
• Drive belt torn or loose
• Contact your service partner
• Contact your service partner
• Wait a few minutes and try again
(overload switch resets automati-
cally)
• Check the work technique
• Remove power supply cord exten-
sion
• Check the voltage rating
• Replace pad
• Clean spray unit
• Replace spray unit
220V~ 100-110V~
60 60
200
43
32
230-240V~ 120V~
50 60
Page
73
76
cm
cm
kg
100-110V~ AC
50 Hz
W
W
238
38 cm
cm
31 kg
230-240V~ AC
50 Hz
800 W
-- W