Chicco goody plus Manual De Instrucciones página 14

buckle.
5. WARNING: To use it with children from birth to approx. 6 months
of age, you must use the shoulder straps, first threading them
through two adjusting holes (Fig. 5), and threading the waist strap
through the vertical holes (Fig. 5A).
The height of the shoulder straps can be adjusted by using the dif-
ferent slots found on the backrest.
6. After laying the child in the stroller, fasten the straps (Fig. 6) by
passing first the two forks (A) inside the shoulder strap buckle (B)
and then inside the crotch strap buckle (C); adjust the height of
the shoulder straps so that they correctly fit your child's shoulders
(Fig. 6A).
Always make sure that the straps are fastened correctly. To unfasten
the strap, press and pull the side prongs.
WARNING: To guarantee the safety of your child, the safety harness
must be fastened at all times.
To make sure that the belts are fastened properly to the anchoring
points, after placing your child inside the stroller, pull the end parts
of the belts firmly.
ADJUSTING THE BACKREST
The backrest can be adjusted to 3 positions.
7. To lower the backrest, lift the adjusting handle located on the rear
of the backrest (Fig. 7). To raise the backrest, simply lift it to the
desired position.
WARNING: The child's weight can make these operations more
difficult.
REAR BRAKES
The rear wheels have linked brakes, which can be applied simulta-
neously on both rear wheels by using the support tube.
8. To brake the stroller, press down on the pedal located centrally
(Fig. 8). To release the brakes, press the pedal in the opposite di-
rection (Fig. 8A).
SUN CANOPY
The hood is already installed on the stroller.
9. To open and adjust the canopy use the front arch (Fig. 9). The
hood can be extended by opening the zipper (Fig. 9A-9B). Fix the
back of the hood onto the backrest using the two snap fasteners
(Fig. 9C) and the velcro fasteners on the sides (Fig. 9D). If you wish
to remove the hood from the stroller, open the zip that covers
the tube above the backrest (Fig. 9E) and pull both sides of the
arch out from the joint to which it is attached, pressing on the
point shown in Fig. 9F and pulling it upwards at the same time.
Complete the operation by undoing the two buttons on the back
of the backrest.
ADJUSTABLE LEGREST
The legrest can be used in 2 positions.
10. To use the legrest in the horizontal position simply push it up-
wards. To lower it, use the button located under the legrest (Fig.
10).
FITTING AND REMOVING THE STROLLER LINING
To remove the lining from the seat, follow the steps below:
11. Detach all the velcro fasteners and snap buttons that connect
the backrest to the hood (Fig. 11A) and remove the straps on
both sides from the plastic hooks that attach the backrest to the
handle tube of the frame (Fig. 11B).
12. On the sides of the seat, remove the velcro fasteners (Fig. 12)
and slip the fabric tab out from the plastic ring on the frame
(Fig. 12A). Complete this operation for both sides of the stroller.
13. Remove the textile part of the legrest from the frame (Fig. 13)
and then the elastic strap (Fig. 13A). Remove the velcro on the
elastic strap, located under the seat, and remove the strap from
the buckle (Fig. 13B). Remove the pocket from the adjustment
button for the backrest and pull all the fabric upwards (Fig. 13C
- 13D).
To put the lining back on the stroller follow the same steps back-
wards.
FOLDING THE STROLLER
WARNING: When opening the stroller, ensure that your child and
any other children are at a safe distance.
Make sure that during these operations the moving parts of the
stroller do not come into contact with your child.
Before closing the stroller, ensure that the storage basket is empty.
The stroller has a closing device that can be used with one hand.
14. To close the stroller, push switch "A" to the left and simultane-
ously press button "B" (Fig. 14); push down on the handle and
the stroller will close automatically. The stroller will automatically
lock in the closed position. When closed, the stroller stands up
on its own (Fig. 14 A-B). To make the stroller even more compact
when closed, the bumper bar can be turned towards the handle
(Fig. 14C).
ACCESSORIES
WARNING: The accessories described below may not be included
in some product versions. Carefully read the instructions for the ac-
cessories that came with the model you have purchased.
SHOULDER STRAPS AND CROTCH STRAPS
The stroller is fitted with padded shoulder straps and a soft crotch
strap to ensure the safety and comfort of your child.
15. For assembly, insert the shoulder straps (Fig. 15) and the crotch
strap in the relevant padding (Fig. 15A).
WARNING: Adjust the waist belt if necessary by pressing on the
buckles.
WARNING: To guarantee the safety of your child, the safety harness
must always be fastened.
RAIN COVER
16. To fit the rain cover, fasten the straps around the stroller's frame
in the positions shown in Fig. 16 (steps to be repeated on both
sides of the stroller).
When you have finished using the rain cover, allow it to dry properly
if it is wet.
WARNING: The rain cover cannot be used on the stroller without
hood, as it may cause suffocation.
WARNING: When the rain cover is fitted on the stroller, never leave
it exposed to direct sunlight with your child inside, as the tempera-
ture will rise considerably.
USING THE CAR SEAT ON THE STROLLER
On the Goody Plus stroller it is possible to fit the following elements,
which can be purchased separately:
• Kaily car seat
• Kiros i-size car seat with Fast In fastening
All car seats for use on the stroller require the special adaptors sold
separately.
WARNING: FOR THE ASSEMBLY AND/OR USE OF THE ITEMS LISTED
ABOVE, REFER TO THE RELEVANT MANUALS.
SOFT CARRYCOT MOUNTING AND REMOVAL FROM THE
STROLLER
The Goody Plus stroller is compatible with the Chicco Soft Carrycot.
To attach the carrycot to the stroller, remove the bumper bar, com-
pletely lower the backrest and place the legrest in the horizontal
position.
17. Turn the rod under the carrycot base until it is completely open
(Fig. 17-17A); hold the textile handles in the transport position
and place the carrycot on the stroller with the foot area facing
the handle of the stroller (Fig. 17B).
18. Fasten the carrycot to the stroller's frame using the appropriate
straps. The carrycot has two straps with a buckle on each side.
Wrap the straps around the stroller bar in the positions shown in
Figure 18, fasten the buckles (Fig. 18A), pull the straps to ensure
a secure attachment (Fig. 18B) and close the second safety lock
(Fig. 18C). Repeat the operations on the opposite side as well.
WARNING: Before use, make sure that the carrycot is properly at-
tached by pulling it upwards.
To remove the carrycot from the stroller, release the buckles and
remove it from the seat.
14