Setting Up And Connecting The Refrigerator; Changing The Door Hinge - Mobicool ML30 Instrucciones De Uso

Setting up and connecting the refrigerator

6 Setting up and connecting the
refrigerator
6.1 Setting up the refrigerator
Optimum cooling performance is assured at ambient temperatures between
+16 °C and +43 °C. In continuous operation, the air humidity may not exceed
90%.
A
NOTICE!
 Avoid installing the device next to heat sources such as heat-
ers, gas ovens, hot water pipes, etc.
 Do not set up the device in direct sunlight.
When installed in a cabinet:
 The ventilation duct must be at least 105 mm x width of the
refrigerator.
 The air passing through the ventilation duct should not be
heated by a heat source other than the refrigerator.
➤ Set up the refrigerator in a dry, sheltered place.
➤ Place the cooler on a firm base.
Ensure that the refrigerator is at least 20 cm away from the wall so that
the heat that arises during operation can be drawn off (see fig. 2, page 4
to fig. 5, page 4).
➤ When installed in a cabinet: Secure the feet of the refrigerator using bolts
(fig. 6, page 5).
6.2

Changing the door hinge

You can also change the hinge of the door so that it opens to the left rather
than the right.
To change the door hinge, proceed as follows (see fig. 7, page 5):
➤ Put the refrigerator on its back.
➤ Remove the eight bolts.
➤ Remove the door together with the hinges.
➤ Remove the two cover caps from the hinge holes on the housing.
➤ Put the two cover caps on the other side over the hinge holes.
12
ML30, ML40
EN