Using A Micro Sd Card - Aukey DR02 J Manual Del Usuario

Using a Micro SD Card

The camera doesn't include internal storage and requires a micro SD card (Class 10+
recommended and 128GB Max supported) to function. A 128GB micro SD card should
store over 10 hours of 4K recordings or 16 hours of 1080p recordings. Use a high-quality,
branded card for maximum reliability. Insert a micro SD card into the camera micro SD
card slot. Later, when the camera is powered on, format it ('Format' option in Dashboard
Camera 'Setup') to prepare the card for first use in the dash camera. Formatting will
permanently erase any data on the micro SD card. For best performance, format
periodically (after backing up any important files). 'Format Warning' in 'Settings' can be
switched on to remind you to do this.
Installation & Powering On/Off
For optimal performance, install the AUKEY DR02 J in the top-center of your windshield
facing directly ahead. Lens direction can be adjusted up and down. Use the cable clips
to help fix the power cable conveniently and safely like in the picture below.
Caution:
We are not responsible for any damage
caused to or by the air bag due to
incorrect placement of the device
or its cable.
To power on, insert the car charger into your car's 12V socket, then connect the included
cable to the car charger and to the USB mini-B port of the DR02 J. After powering on
each time, the system will start recording automatically. To power off, disconnect the USB
mini-B cable.
Note: Use the included cable to ensure optimum performance of AUKEY DR02 J
Windshield
- 05 -
Best mounting
location