Care And Cleaning - Kenwood AT503 Instrucciones

119699 Iss 1 LV AT503-AT504 Eng_Fre_Sp:Layout 1
AT503 for use on
Kitchen Machine Chef
AT504 for use on
Kitchen Machine Major
and Cooking Chef
Before using your Kenwood
attachment
Remove all packaging.
G
The flexible beater is designed for
creaming and mixing soft ingredients.
It is not to be used with heavy
recipes such as dough or hard
ingredients, for example those
containing fruit stones, bones or
shells.
1 Carefully fit the flexible wiper blade
onto the tool by locating the base of
the wiper blade into the slot
feed one side into the groove before
gently hooking the end in place
Repeat with the other side
2 With the mixer switched off, insert
the flexible beater and lower the
mixer head. Check the position of
the beater in the bowl
should be in contact with the bowl
surface so that it gently wipes the
bowl during mixing.
3 If the clearance needs to be
adjusted, raise the mixer head and
remove the beater.
4 Using the spanner provided loosen
the nut sufficiently to allow
adjustment of the shaft
the beater closer to the bottom of
the bowl, turn the beater shaft
counter-clockwise. To raise the
beater away from the bottom of the
bowl turn the shaft clockwise.
5 Tighten the nut.
6 Fit the beater to the mixer and lower
the mixer head. Check its position
(see point 2). Repeat the above steps
as necessary until the beater is set
correctly. Once this is achieved
tighten the nut securely.

care and cleaning

1 Always remove the flexible wiper
blade from the tool before cleaning
2 Wash the flexible wiper blade and
tool in hot soapy water, then dry
thoroughly. Alternatively the parts can
be washed in a dishwasher.
Note: Please inspect the condition of
the tool body before and after use
and also regularly inspect the
condition of the wiper blade and
replace it if there are any signs of
wear.
, then
Any other servicing should be
G
.
performed by an authorized service
.
representative.
. Ideally it
. To lower
3
.
24/10/12 08:11 Pa