Anatomy Of The Dovetailer Jig; Dovetail Router Bit And Bearings - General Dovetailer Manual Del Usuario

860 Dovetailer Manual R4-120811_awb 12/8/11 3:07 PM Page 5

ANATOMy OF THE DOVETAILER JIG

– Jig Assembly
– Depth Plate
– Template Position Rules
2A
Depth Adjuster Plate
– Depth Measuring Working Surface
3A
– Edge Alignment Teeth
3B
FIG.4
DOVETAIL JIG ASSEMBLy
NOTE: Your jig comes fully assembled for use. The addition of the router control knobs aids in the
use of this jig on router tables.

DOveTaIl rOUTer BIT anD BearInGs

Included bearings are 1/2 in. outside diameter (OD) and 1/4 in. inner diameter (ID). Router sleeves
or bushings can be used in place of the guide bearings as long as they are also 1/2 in. OD.
Included router bit is 14˚ x 1/2 in. Other bits can be substituted provided they have a 1/4 in.
diameter shank and have no greater diameter than 17/32 in.
Caution: Keep fingers on control knobs only when using the jig on a router table.
– Template Lock Screws
– Face Clamp
– Face Clamp Thumb Screws (4)
5