Safety Rules - UltraCOOL CP70 Guía De Uso Y Cuidado

Safety Rules

1. Unit must be in the Off Position and Unplugged from power receptacle when
performing any maintenance.
2. To reduce the risk of electric shock, plug unit into a properly grounded 120 Volt
A.C., 60 Hz receptacle.
3. To reduce the risk of electric shock, install only on a circuit protected with a
Ground Fault Circuit Interrupter (GFCI).
4. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should
be supervised to ensure that they do not play with the appliance.
5. Do Not operate any fan with a damaged cord or plug. Discard fan or return to
an authorized service facility for examination and/or repair.
6. Do Not run cord under carpeting. Do Not cover cord with throw rugs, runners or
similar coverings. Do Not route cord under furniture or appliances. Arrange
cord away from traffic area and where it will not be tripped over.
WARNING: To reduce the risk of fire or electric shock, do not use this fan with
any "solid-state fan speed control device."
Assembly
For shipping purposes, the base and casters have been stored inside the body.
1. Open the back of the unit by removing 2 screws at the top of the back, tilt the
frame back and press in at the bottom (on PUSH button) to release the back and
access the contents. Disconnect water hose from media frame.
2. Remove casters, base and hardware from body cavity and set aside for
installation.
CAUTION: Do not damage hose connecting pump to media frame. When
removing back disconnect the water hose that connects the pump to the media
frame.
3. Reattach water distribution hose onto media frame, reposition media frame onto
lower section and reinstall two screws fastening the body together.
2
1
PUSH
2
3