Ranger 25 - 92831
2. Explanation of Symbols on the Machine
For safe operation and maintenance, symbols are carved in relief on the machine.
According to these indications, please be careful not to make any mistake
The port to refuel "MIX GASOLNE"
Position: Fuel cap
The port to top up chain oil
Position: Oil cap
Setting the switch to the "O" position, the engine stops immediately.
Position: Rear-left of the unit
Starting the engine. If you pull out the choke knob (at the back-right of
the rear handle) to the point of the arrow, you can set the starting mode
as follows:
Position: Upper-right of the air cleaner cover
The screw under the "H" stamp is The High-speed adjustment screw.
The screw under the "L" stamp is The Slow-speed adjustment screw.
The screw at the left of the "T" stamp is the ldle adjustment screw.
Position: Left side of the rear handle
Shows the directions that the chain brake is released (white arrow) and
Activated (black arrow).
Position: Front of the chain cover
First-stage position-starting mode when the engine is warm.
Second-stage position-starting mode when the engine is cold.
20