Samsung BD-H6500 Manual Del Usuario página 21

Wired - Manual
Ğ
If you have a static IP address or the Automatic
procedure does not work, you'll need to set the
Network Settings values manually.
Follow Steps 1 and 2 in Wired - Automatic, and
then follow these steps:
1. Select Network Status. The product
searches for a network, and then displays the
connection failed message.
2. On the bottom of the screen, select IP
Settings, and then press the v button.
The IP Settings screen appears.
3.
Select the IP Setting field, and then press the
v button.
4. Select Enter manually in the IP Setting field,
and then press the v button.
5. Select a value to enter (IP Address, for
example), and then press the v button.
Use the number keypad on your remote
control to enter the numbers for the value.
You can also enter numbers using the ▲▼
buttons. Use the ◄► buttons on the remote
control to move from entry field to entry field
within a value. When done with one value,
press the v button.
6.
Press the ▲ or ▼ button to move to another
value, and then enter the numbers for that
value following the instructions in Step 5.
7.
Repeat Steps 5 and 6 until you have filled in
all values.
| NOTE |
\ You can get the Network values from your Internet
provider.
8.
When finished entering all the values, select
OK, and then press the v button. The
product verifies the network connection and
then connects to the network.
Wireless Network
You can set up a wireless network connection in
four ways:
- Wireless Automatic
- Wireless Manual
- WPS(PBC)
- WPS(PIN)
When you configure the wireless network
connection, any wireless network devices currently
connected through the product or, if applicable,
the product's current wired connection, will be
disconnected.
Wireless - Automatic
Ğ
1. In the Home screen, select Settings, and
then press the v button.
2. Select Network, and then press the v
button.
3. Select Network Settings, and then press the
v button.
4. Select Wireless in the Network Settings
screen, and then press the v button. The
product searches for and then displays a list
of the available networks.
Network Settings
Select your network type.
Network type
Wireless network
iptime23
iptime
solugen_edu#2
Refresh
5.
Select the desired network, and then press
the v button.
6.
On the Security screen, enter your network's
Security Code or Pass Phrase.
Enter numbers directly using the number
buttons on your remote control. Enter letters
by selecting a letter with an arrow button, and
then pressing v button.
21
English
Wireless
You can connect your Blu-
ray player to the internet.
Please select which wireless
network to use.
WPS(PBC)