Care & Maintenance; General Care - Blackstone 1940 Manual Del Propietário

Model 1940 | Owner's Manual | Care & Maintenance
!
WA R N I N G
CARE & MAINTENANCE
When not in use, turn unit
controls and gas source OFF.
Regularly clean your appliance between uses, especially after extended
periods of storage. In order to extend the life and condition of unit,
!
WA R N I N G
follow best practices detailed in this manual.
This appliance will be hot
during and after use. Use
Section 01
insulated oven mitts or

GENERAL CARE

gloves for protection from
hot surfaces or splatter from
cooking liquids.
VALVE CHECK
! Ensure gas is off at the supply shut
C A U T I O N
off valve before checking appli-
NEVER handle hot parts
ance valves. Knobs must be locked
with unprotected hands. in OFF position.
01. To check valves, push in knobs
and release. Knobs should
spring back.
02. If knobs do not spring back,
replace valve assembly before
using appliance.
03. Rotate knobs to LOW position
then turn back to OFF position.
Knobs should turn smoothly.
16
GENERAL CLEANING
Ensure that the appliance and its
components are sufficiently cool
before cleaning.
• Be sure to keep the ventilation
opening(s) of the cylinder enclo-
sure free and clear from debris.
• Baked-on grease deposits may
require the use of an abrasive
plastic cleaning pad. Use only
in direction of brushed finish to
avoid damage.
• DO NOT use abrasive pad on areas
with graphics.
• If a bristle brush is used to clean
any of the cooking surfaces,
ensure no loose bristles remain on
cooking surfaces prior to cooking.
BURNER MAINTENANCE STORAGE
In most circumstances, burning
• In order to extend and maintain
residue off after cooking will keep
the life and condition of your
burner clean.
appliance, we strongly
recommend that the unit be
• Be sure that the flow of combus-
covered when left outside for any
tion and ventilation air is
length of time, especially during
not obstructed.
the winter months.
• Burner should be removed and
• When LP cylinder is connected
cleaned annually or whenever
to appliance, store appliance
heavy build-up or insects/insect
outdoors in a well-ventilated
nests are found in order to ensure
space and out of reach of children.
that there is no blockage in the
LP cylinder should only be stored
burner portholes or venturi tubes.
outside, out of reach of children,
and in a cool, dry place.
• Use pipe cleaner to clear obstruc-
tions. A wire brush may be used
• Store appliance indoors ONLY if
to remove corrosion from the
LP cylinder is turned off, discon-
burner surfaces. (Please refer-
nected, removed from appliance
ence the Cleaning the Burner
and stored outdoors.
Assembly section)
• When removing appliance from
• When refitting burner, check that
storage, clean burner assembly
the venturi tubes of the burner fit
before starting appliance. (Please
over valve outlets.
reference the Cleaning the Burner
Assembly section.)
AF TER EACH USE
PLASTIC PARTS: Wash with warm
soapy water and wipe dry.
PAINTED SURFACES: Wash
with mild detergent or nonabra-
sive cleaner and warm soapy
water. Wipe dry with soft nonabra-
sive cloth.
STAINLESS STEEL SURFACES:
To maintain appliance frame's high
quality appearance, wash with mild
detergent and warm soapy water.
Wipe dry with a soft cloth after
each use.
Care & Maintenance | Owner's Manual | Model 1940
!
WA R N I N G
A clogged burner
tube can lead to a fire
beneath the appliance.
!
WA R N I N G
This appliance is not
intended for and should
never be used as a heater.
!
WA R N I N G
NEVER operate this
appliance unattended. Keep
children and pets away
from appliance at
all times.
!
WA R N I N G
The use of alcohol,
prescription or
non-prescription drugs may
impair the consumer's ability
to properly assemble or
safely operate the appliance.
!
C A U T I O N
For residential use
only. DO NOT use for
commercial cooking.
!
C A U T I O N
DO NOT use Citrisol,
abrasive cleaners,
de-greasers or a
concentrated cleaner on
plastic parts.
Damage to and
failure of parts may result.
17