Need Help - Blackstone 1940 Manual Del Propietário

Model 1940 | Owner's Manual | Assembly Guide
S T E P 13
burner tubes.
S T E P 14
on the main body by aligning the 4 pins to the holes of the body.
Make sure the front pins are fully
seated in the holes, then push the
griddle top and hood back to lock
the griddle in place.
14
Ensure the igniter needles are placed 3-7 mm above the
3-7 mm
With the help of another person, place the griddle top and hood
CLEANING THE GRIDDLE COOKING SURFACE
S T E P 15
Install the hood handle
with handle bezels on the hood with
two (2) M6x16 screws.
S T E P 0 1
each use, cool griddle below 300° F.
Scrape food debris with spatula or
straight metal scraper.
S T E P 0 2
surface with paper towel.
S T E P 1 6
Hang LP Tank (NOT INCLUDED) on tank hanger. Be sure that it
is firmly seated on both upper and lower supports and connect hose. (Please
reference the Connection & Removal section of the Fuel | Propane – 20lb.
Tank chapter.)
S T E P 0 3
into approximately 6" sections
(width of scraper tool). Apply a
S T E P 1 7
Proceed to the Griddle Seasoning Instructions section of the
small amount of water onto first
Care & Maintenance chapter. Enjoy cooking outdoors on your Blackstone 22"
section with a bottle and then
Griddle Cooking Station!
scrape the water and debris toward
the grease trap. Move to the next 6"
section and repeat.
DO NOT USE MORE THAN TWO
TABLESPOONS OF WATER
AT A TIME.
1/4 cup of table salt may be used to
buff off stuck food residue.
S T E P 0 4
paper towel and dry completely.
S T E P 0 5
cooking oil to maintain seasoning
and protect the griddle top.
Care & Maintenance Assembly Guide | Owner's Manual | Model 1940
!
WA R N I N G
NEVER APPLY COLD
WATER ACROSS THE
WHOLE SURFACE OF A
HOT GRIDDLE AT ONCE.
This may cause warping.
To clean griddle after
!
C A U T I O N
DO NOT USE SOAP ON
THE GRIDDLE COOKING
SURFACE. This will destroy
the griddle's seasoning.
Wipe down griddle
Divide griddle surface
Wipe again with a

NEED HELP?

Register your Blackstone product at
blackstoneproducts.com/register
and contact Blackstone Customer Service
for missing parts, assembly and operation
questions:
 PHONE:
Apply thin coat of
435-252-3030 ext 1
EMAIL:
support@blackstoneproducts.com
ONLINE:
blackstoneproducts.com/pages/support
15