Receiving Measurements Automatically; Rainfall; Hi/Lo Alert - National Geographic Colour Weather Center 5in1 Manual De Instrucciones

21 Receiving measurements automatically

Once power is restored, the base station will begin to display indoor readings and the first readings re-
ceived from the outdoor sensor will be displayed within approximately 3 minutes of commissioning.
If no signal is received, proceed as follows:
Press the SENSOR button for approx. 2 seconds to initiate the reception of the measured values
again.

22 Rainfall

The amount of precipitation is displayed on the base station in millimeters or inches that has accumu-
lated over a period of time, based on the current precipitation rate.
Rainfall rate
Select display mode
Press the RAIN key repeatedly until the desired time period is shown on the display:
RATE
DAILY
WEEKLY
MONTHLY
Select measurement unit (millimeters or inches)
1. Press the RAIN key for about 3 seconds to enter unit setting.
2. Press the UP or DOWN key to toggle between mm (millimeters) and in (inches).
3. Finally, press the RAIN key to save the settings and exit settings mode.
NOTICE! The readings are automatically updated every 6 minutes.

23 HI/LO Alert

HI/LO alert are used to alert you of certain weather conditions. Once activated, an alarm sound is
triggered and the alert icon flashes as soon as a set value is reached. Supported areas and alarm
types:
Area
Indoor temperature
Indoor humidity
Outdoor temperature
Outdoor humidity
Rainfall (daily)
Wind speed
HI AL = High alert / LO AL = Low alert
*Daily rainfall since midnight
HI/LO alert setting
Daily rainfall
Current precipitation of the last hour
Total precipitation of the current day, measured from midnight
Total precipitation of the current week
Total precipitation of the current month
Weekly rainfall
Type of alert available
HI AL / LO AL
HI AL / LO AL
HI AL / LO AL
HI AL / LO AL
HI AL*
HI AL
Monthly rainfall
39 / 76