Kohler K-1528 Guia De Instalacion página 6

5. Module Separation and Re-Assembly
Multi-piece modules are shipped assembled, and must be separated for transportation into the
installation area and for the application of sealant.
Cover the floor or other level surface with a cloth or soft padding that will protect the module and
joining surfaces when they are laid down.
Lay the module face down.
Loosen and remove all the nuts and washers. Keep all fasteners for reassembly.
Slide the alignment clips above the section joint, but do no remove the clips completely.
Remove the split washers that act as spacers during shipping.
Remove the bolts and separate the module sections.
With help, carefully move the sections to the installation area, setting them again on a covered, level
surface. Move the bottom segment of the module into the re-assembly area first.
Re-assemble the sections by placing the upper sections over the lower sections.
Align the sections by sliding an alignment clip over the alignment strip of each block. Start at each
door column, then align the back corners, the back wall next, and lastly, the side walls.
Slide a flat washer onto each of the bolts and insert the bolts into the mounting blocks located on
the side and back walls. Do not insert the bolts at the door columns and back corners at this time.
Slide a flat washer and a split washer onto the end of each bolt and loosely thread on the nuts. Do
not tighten.
1010416-2-C
Alignment
Clip
Section
Joint
Alignment
Strip
Bolt
Washer
Mounting
Block
Washer
Nut
6 Kohler Co.