Little Seeds 9190015COM Manual Del Usuario página 28

Step 20
IMPORTANT: THIS UNIT MUST BE SECURE TO THE WALL TO HELP PREVENT TIPOVER. FOLLOW
THESE INSTRUCTIONS TO INSTALL THE ANTI‐TIPPING SAFETY BRACKET PROVIDED WITH THIS
PRODUCT.
OPTION 1: Attachment into a wall stud
(preferred method)
Using a stud finder, locate a stud in the
wall. Place your unit against the wall, with
the safety bracket aligned in this location.
To make driving the screw easier, you can
drill a 1/8" diameter pilot hole (3mm)
through the safety bracket into the stud.
Drive the screw through the safety bracket
into the wall stud. Tighten the screw that
was not fully tightened in step 1.
OPTION 2: Attachment into drywall
Locate your unit where desired against a
wall and mark the wall through the safety
bracket, then move your unit aside. Drill a
3/16" diameter hole (5mm) into the
wallboard. Tap the wall anchor into the
hole until it is flush. Move your unit into
location and fasten the wall bracket to the
wall anchor with the screw. Tighten the
screw that was not fully tightened in step
1.
littleseedskids.com
14c
14d
28
For Masonry, Concrete, or other
wall materials:
Consult your local hardware store
for appropriate anchors to securely
attach the safety bracket.
hole
14d
14c
stud
wallboard