Cleaning The Appliance - La Marzocco Vulcano Serie Manual De Instrucciones

DISCONNECT THE APPLIANCE'S
POWER SUPPLY BY UNPLUGGING IT
BEFORE CLEANING. THE APPLIANCE
MUST NOT BE CLEANED USING
WATER JETS.
Do not install the appliance in rooms
where water jets are used for cleaning.
THE APPLIANCE MUST BE CLEANED
PERIODICALLY BY SKILLED TECH-
NICAL PERSONNEL ONLY.
Use perfectly clean, disinfected cloths
or brushes for cleaning.
Do not use abrasive products as these
are liable to take the sheen off shiny
parts.
Hopper
LOCKING SLIDE HUB
HOPPER
Wash the hopper once it has been
removed from the appliance, using
neutral soap and water, rinse abundantly
with lukewarm and dry thoroughly.
To clean the internal surfaces it is
necessary to remove the hopper, slip off
the locking slide by pushing down the
click. Then turn the hub clockwise and
lift to remove it (see picture).
It is advisable to clean the hopper peri-
odically.
To reassemble completely the hopper
please proceed in the reverse order with
previous instructions.
Once the hopper has been cleaned it
must be put back on the appliance
properly fixing it with the relevant pins.
Grinding system
As explained in the paragraph "
ADJUSTING
" remove the hopper and the
GRINDING
adjustment level.
Unscrew the adjustment disk by turning
it clockwise. After having removed the
upper blade holder, clean the grinding
blades, threads and the entire system
thoroughly using a clean brush or cloth.
To clean the threads of the grinder
please use a small wire brush.
We recommend to check that the
threads of the grinder and of the
grinding adjustment disk are clean: to
do so screw the adjustment disk anti-
clockwise
without the upper blade holder until the

14. Cleaning the appliance

end. If the grinding adjustment disk
can not turn easily, than it is necessary
to clean again. If the cleaning opera-
tions are not done as above the risk is to
damage the threads.
GRINDING
ADJUSTMENT DISK
UPPER GRINDING
BLADE HOLDER
GRINDING
ADJUSTMENT SPRINGS
Please check that the grinding adjust-
ment springs are on their place. Having
refitted the upper grinding blade holder
in the relevant slot, please lubricate,
with grease suitable for food contact,
the threads of the grinding adjustment
disk and its underneath surface which
touches the upper grinding blade
holder.
Screw the adjustment disk by turning it
anticlockwise, place the adjustment
level and fix it on adjustment disk with
the relevant screws
After having refitted the hopper properly
adjust grinding as required.
11