Preparing The Remote Control; Pairing The Remote Control - Home Decorators Collection 51556 Guía De Uso Y Cuidado

Preparing the Remote Control

Pairing the Remote Control

NOTE: The remote control has already been paired to the ceiling fan
for your convenience. If you have two of the same model fans in your
home, please follow the steps below to control each fan independently.
□
Slide the dip switch in the battery compartment to the "1" setting.
□
Confirm that the power to the fan is off at either the wall switch or
breaker box.
□
Return power to the fan at the wall switch or breaker box.
□
Press and release the "Learn" button located in the remote's battery
compartment within 30 seconds.
□
If pairing is successful, the fan's light kit will flash and the blades
will begin to spin.
Setting the light function on your remote
NOTE: The battery will weaken with age and should be replaced
before leaking takes place as this will damage the remote control.
Dispose of used battery properly and keep the battery out of the reach
of children.
NOTE: The switch marked ON/DIM controls the dimming function of
the lights: If using non-dimmable bulbs, use a ballpoint pen or small
screwdriver to set the switch to ON to disable the dimming function.
If using dimmable bulbs, set the switch to DIM to enable the dimming
function.
NOTE: This fan includes non-dimming CFL bulbs. If you would like to
use the dimming function, please install dimmable light bulbs (60-Watt
maximum incandescent bulbs).
□
Remove the battery cover by pressing firmly on the arrow and
sliding the cover off.
□
If your fan is equipped with a light kit and using dimmable bulbs,
slide the dip switch from "on" to "dim" (for non-dimmable bulbs,
the dip switch must be set to "on").
□
Install two 1.5V AAA batteries (included).
□
Replace the battery cover on the remote control.
13
Please contact 1-800-986-3460 for further assistance.
HOMEDEPOT.COM/HOMEDECORATORS