Programming For Vcr - GE RM94940 Manual De Instrucciones

94940 Revised Size 10/18/02

Programming For VCR

Most GE, RCAand ProScan VCRs will not require
programming. Check to see if your VCR responds to
the remote before you begin programming.
1. Manually turn on the VCR. Find the three digit
code for your VCR at the back of the instructions.
2. Press and hold the
CODESEARCH button
until the INDICATOR
LIGHT lights, then
release the CODE
SEARCH button.
3. Press and release the
VCR button (The INDI-
CATOR LIGHT will blink
then remain lit.
4. Enter the code using
the Number Buttons.
After your code is
entered, the INDICATOR
LIGHT will turn off. If the
code is not valid, the
INDICATOR LIGHT will
blink. Check the code list
and repeat process.
5. Aim the remote at
your VCR and press the
ON•OFF button. Your
VCR should turn off.
NOTE: If your VCR does
not respond, try all the
codes for your brand. If
the codes do not work,
or your brand is not listed,
try the Code Search
method on Page 12.
6. With your VCR on, press CHAN+ (CHANNEL
UP). If the VCR responds, no further programming is
required.
7. Enter your code here
for easy reference.
12:22 PM Page 8
7