Samsung POWERbot SR1AM70 Serie Guía De Referencia Rápida página 7

2
WARNING
Power related
• To prevent the risk of electric shock or
fire:
– Do not damage the power cord.
– Do not pull the power cord too hard or
touch the power plug with wet hands.
– Use only power sources that provide
between 100 and 240 volts. Do not
plug the POWERbot into a multi-outlet
power strip. Do not place the power
cord where it can be stepped on,
tripped over, or where the POWERbot
can run over it.
– Do not use a damaged power plug,
power cord, or loose power outlet.
• Clean dust or any foreign matter off the
prongs of the power plug.
– There is a risk of electric shock or
malfunction.
Before use
• Do not use POWERbot near a heater or
combustible materials.
– Do not use powerbot near fire or
flame such as a movable heater, a
candlelight, a desk lamp, a fireplace
etc. or in a place where combustible
materials such as gasoline, alcohol,
thinner etc. exist.
• Make sure there are no dangerous
objects around the POWERbot's cleaning
area to prevent collision and unplug any
electric heaters or fans.
• The POWERbot is intended for specific
household use. Do not use it in an attic,
basement, storage area, industrial
building, outside, in places with moisture
(such as a bathroom or laundry room),
on a table or on shelves.
– The POWERbot can be damaged or
malfunction.
-5
Safety information
English-7
• Be sure the POWERbot does not pass
through or touch any kind of liquid.
– The POWERbot can be severely
damaged and it may contaminate other
areas if the wheels pass through liquid.
• Attach the boundary markers to places
where the POWERbot may fall such as
the top of a staircase or a bannister to
prevent product damage and injury.
– Please keep the cliff sensor clean at all
times for safety.
• Do not spill any liquid on the docking
station.
– There is a risk of fire or electric shock.
• Do not use the docking station for
anything other than its intended
purpose.
– There is a risk of fire or severe damage
to the docking station.
• Always keep the cliff sensor clean for
your safety.
In use
• If any abnormal sounds, smells, or smoke
come from POWERbot, immediately shut
off the POWERBOT using the emergency
switch on the bottom of POWERbot, and
then contact a Samsung service center.
Cleaning and maintenance
• If the power cord is damaged, contact
a Samsuing service center to get it
replaced by a certified repairman.
– There is a risk of fire or electric shock.
• Contact a Samsung Electronics service
center if you need to replace the
batteries.
– Using batteries from other products
can cause the POWERbot to
malfunction.